Start-Up And Operation - Bartscher MX 235 Manual

5.2 Start-up and operation

Start-up
The device must be started according to the instructions below and in the specified
order.
1. Positive result of inspection in range of preparation;
2. Positive result of inspection in range of electric supply;
3. Connection of plug to appropriate socket;
4. Positive result of inspection in range of assembly;
5. Positive result of inspection in range of control before
start-up;
6. Positive result of inspection in range of condition of all
protective devices.
7. Place the food products manually in the pot.
8. Holding the device with both hands in
appropriate places:
a. put the mixing stick in the pot.
b.
start the device with use of ON/OFF switch, which
must be pressed until all food articles are processed.
9. When the processed food articles obtain desired properties, turn the device off and
put on appropriate work surface.
10. Remove the processed product from the pot: pour it into appropriate dish, holding
the pot with both hands.
WARNING!
Never immerse the device in the pot with processed food
products deeper than the immersion mark. Never start the
device on the idle run.
CAUTION!
Periodically check the rubber seal under the
blade (fig. on the right) and replace when
damaged or worn.
Good condition of the seal prevents penetration
of processed products into the device, which
may lead to damages.
- 32 -
Rubber seal