Table of Contents
Advertisement
Chapter 2. Camera Installation
2-1. Wall Mount installation
Fix the camera
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the
external cable is not. You are recommended to install this product below the edge of eaves to prevent
the cable from being externally exposed.
1)
Paste the mount hole sticker on the position that you want to install.
2) Use the mount hole sticker to make a hole of 30mm in diameter for passing cable, and drill
another four holes on the wall to fix bracket mount.
3) Insert the anchors to fix the screws with the Mount panel.
Adjust camera angle from bracket mount (Please refer the photo as below)
1) Use the Hexagon wrench to loosen the bolt and to rotate the bracket to suitable position.
2) Adjust horizontal, vertical or rotate camera body angle of the camera.
3) Use the Hexagon wrench to tighten a bolt after adjusting the camera.
14
Advertisement
Table of Contents
