Advertisement
Hardware Installation
1. Opening Dome Cover
First, use the supplied
screwdriver to loosen the four
screws and detach the dome
cover from the camera base.
Then, follow the steps below
to install the camera to either
a ceiling or a wall.
2. Connect & assembly RJ45 Ethernet Cable
a. Drill a hole on the rubber seal
plug and insert an UTP cable
through the opening.
b. Strip part of the sheath from the
UTP cable.
c. You will need an RJ45 crimping
tool to attach the Ethernet wires
to a connector. When done,
connect the cable to the
camera's Ethernet RJ45 socket.
d. Feed the Ethernet cable from
the bottom of the camera and
through the hole. Attach the
rubber seal plug for water proofing and then fix cable with the fixed bracket.
3. Connecting DC Power Cable
a. Add the supplied rubber washer to the cable as shown in the picture.
b. Feed the cable from the bottom of the camera and fix the cable with the
Connect the DC supplied power & alarm I/O& Audio in/out cables.
4
bracket.2
Advertisement
