Martin XHD QC 1 Installation Manual page 26

© Martin Engineering GmbH
NOTE
If there are any signs of a malfunction, turn off the relevant parts of
the conveyor belt. To receive support, contact Martin Engineering
or a representative. DO NOT operate the conveyor belt system
until the reason for the problem is known and a solution is found.
CAUTION! DANGER OF DAMAGE!
Do not let the blades wear out beyond the wear line, since it can
cause serious damage to property.
Inspect cleaner blades regularly and replace them in time!
6. If the cleaner blades are worn out, replace the blade according
to the instructions in chapter 6.3.
7. Clean all warning labels. Replace any warning labels which are
illegible. Warning labels may be purchased from Martin Engi-
neering or an authorised dealer.
CAUTION! FLYING PARTS!
Tools or installation parts which are left behind can fall from a
moving conveyor belt and may cause minor injuries and damage
to property.
After installation, first remove the tools from the place of installa-
tion and from the conveyor belt before switching on the power sup-
ply.
8. Remove all tools from the working area.
9. Switch on the conveyor belt.
WARNING! DANGER OF INJURY!
Body parts and/or clothing may get caught and pulled in by rotat-
ing parts or by the moving conveyor belt.
Do not touch or reach into the conveyor belt system and its acces-
sories during its operation.
24 M3504UK-10/15