Amana 18 Cu. Ft Service page 35

Ice Maker
Shunt Connection
A wire shunt made from an insulated piece of 14-
gauge wire with the ends stripped back about 5/8 inch
(1.5 cm).
MODULE OHMMETER CHECKS
(NO POWER TO ICE MAKER & EJECTOR
BLADES IN END OF CYCLE POSITION)
TEST POINTS COMPONENT
L - H MOLD HEATER
L - M MOTOR
MODULE VOLTAGE CHECKS WITH METER OR TEST LIGHT
(POWER TO ICE MAKER)
TEST POINTS COMPONENT
L - N MODULE
T - H BIMETAL
L - H HEATER
L - M MOTOR
N - V WATER VALVE
Disassembly Procedures
Cover
Pull water adjustment knob first and snap off cover.
Note knob position and reinstall in same position for
same water fill.
!
To avoid possible electrical shock always turn off
power before beginning any disassembly.
MODULE
OHMS
POSITION
ATTACHED TO
SUPPORT
SEPARATED
16,100
FROM HEATER
LINE
0 VOLTS
VOLTAGE
POWER OK NO POWER
OPEN CLOSED
ON
ON
ON
CAUTION
Module, Motor, and Support Assembly
Insert phillips driver in access ports in module.
Loosen both screws. Disconnect shut-off arm. Pull
mold from support assembly. To remove module only,
remove three phillips screws and pull module out of
264
housing.
Shut-Off Arm
Pull out from white bushing. Reinsert to full depth. Follow
steps 1, 2, and 3 below.
1. Push arm into
center slot in bushing -
bottom out.
OFF
OFF
OFF
Water adjustmet
knob location
(not on all models)
3. Arm should be
inside housing
edge.
Module and Heater Assembly
Remove module and support assembly. Install on
new mold and heater assembly.
A - 3
Into Bushing
Shut-off arm
Down position
RS1200004 Rev. 0
Fill cup
2. Push arm
through fill
cup flange hole
past notch