Amana 18 Cu. Ft Service page 45

Door
shim
Center
hinge pin
Screws
Center hinge
bracket
Center Hinge Nomenclature
7. Pull tape off freezer door and lift door off unit. Set
door on a padded surface to prevent damage to
finish.
8. If clearance requirements so dictate, remove center
and lower door hinges:
A. Use No. 2 Phillips screwdriver to remove 3
screws from center hinge bracket. Remove and
retain bracket, screws, and all shims.
B. Remove toe grille by pulling it directly away from
unit, and pop plastic cap off bottom hinge.
Hinge
shims
Installation Instructions
NOTE: Grille and cover are fragile: keep both parts safe
from harm.
Screws
Toe grille
Bottom
hinge cap
Bottom Hinge Nomenclature
C. Remove bottom hinge pin and all shims from
bottom hinge bracket. Note number of shims.
Retain all parts.
D. With 3/8" nut driver, loosen 3 mounting screws
from bottom hinge bracket. Remove and retain
bracket and screws.
Situate the unit
1. Wrap refrigerator carefully with blanket or appliance
pad. Slide appliance cart under side of unit. Thread
cart strap around refrigerator and tighten strap.
2. Move refrigerator in front of final location. Remove
cart strap, cart and padding.
3. You must decide what to do next.
• If door reversal is called for, skip to Door
Reversal or (if unit has contour doors) to Contour
Door Reversal.
• If door reversal is not called for and unit has an
icemaker, perform Step 4 and then skip to Water
Supply.
• If door reversal is not called for and unit has no
icemaker, perform Step 4 and then skip to Final
Steps.
4. Rehang doors by reversing removal procedure.
B - 3
Shim
Bottom
hinge bracket
Brake foot
RS1200004 Rev. 0
Button
plug
Bottom
hinge pin