Amana 18 Cu. Ft Service page 52

Installation Instructions
Water supply
1/4" Copper tubing
Brass ferrule
Refrigerator
d. Slide water-supply tube into water-valve inlet port.
Slide ferrule and nut down to inlet port. Start nut
onto threaded inlet port. Turn nut down finger tight
and finish with a spanner.
2. Confirm that connection is secure by pulling on
copper tubing.
3. Turn on water supply valve at household plumbing
and check system for leaks.
4. Use slack in tubing to form service loop behind
refrigerator taking care, as you do so, not to kink
the tubing.
Final Steps
1. Plug in power cord.
2. Move refrigerator into final location.
3. Level refrigerator per instructions in the owner's
manual.
RS1200004 Rev. 0
4. Align refrigerator door.
Brass nut
Threaded
water-valve inlet
Rear roller
adjustment screw
5. Clean the unit.
NOTE: Do not use abrasives or harsh cleansers.
B - 10
a. Lay a carpenter's level across front edge of unit.
b. At bottom of unit, in front: Turn roller-adjustment
screws and/or use shims as needed to raise or
lower corners until unit is level and stable.
b. At top of unit, side opposite hinges, refrigerator
door corner should be about 1/8" higher than
corner at the hinge. Door will sag level when
loaded with food.
c. Lay a dime on refrigerator door gasket. Use dime
to space refrigerator doors 11/16" from edge of
cabinet.
d. Tighten all hinge screws.
• Get a clean sponge or clean, soft cloth and a
solution of warm water and mild detergent.
• Wash door liners, door gaskets and painted,
exterior surfaces of unit.
Bottom
hinge bracket
Front roller