Dc Fan And V Board-1 - Sony RM-PJ25 Service Manual

1-3-15. DC Fan and V Board-1

n
When removing the V board, perform the procedure in Sections 1-3-15 and 1-3-16.
5 Remove the lamp power connector
assembly from the hook of fan (CH)
bracket and hole of the plate clamp.
Hole of plate clamp
Hook of fan (CH) bracket
Place the harness at a right
angle as shown in the figure.
Harness
Hook of bottom cover assembly
1-16 (E)
4 Four screws
(BVTP3 x 12)
A
Lead with connector
GA board
(LVDS)
CN600
CN602
CN301
Tape
CN400
Marking is printed on the top.
A
A
A
Front side
7 G board holder block
DC fan block
Front side
1 Open the two edge clamps
When installing the harness,
the harness should not protrude
exceeding the shaded area.
G board holder block
Hook of plate clamp
3 Pull out the harness from the hole.
2 Remove the harness from the eight
hooks.
Harness of the lead with connector
(LVDS) should not override on top
of the chassis screw.
Chassis screw
QA board
CN1001
CN301
A
6 Four
dowels
Front side
Lead with connector
(LVDS)
Tape
Chassis
VPL-HW40ES