C Board-1 - Sony RM-PJ25 Service Manual

1-3-6. C Board-1

t When removing the C board, perform the procedure in Sections
1-3-6 to 1-3-8.
1 Tape
7 Two fan connectors
HB board
CN20
Harness
Fuse connector assembly
TL board
CN60
!= Three harnesses
1-8 (E)
3 Shield (PW)
2 Four screws
4 Two screws
(BVWHTP3 x 12)
5 Lamp power
connector assembly
6 Six hooks
0 Loosen screw.
!- Remove the fuse connector
assembly in the direction of the
arrow.
Fuse connector assembly
C board
CN1000
Optical unit
(PSW3 x 8)
Bottom cover
assembly
When installing the GND wire harness,
insert the GND wire harness in between
the optical unit and the bottom cover
assembly.
Pull the GND harness front to
give tension.
C board
CN2000
!\ Harness
The lug terminal should not
protrude exceeding the chassis.
Front side
Chassis
8 Screw
(PSW3 x 8)
9 GND wire
harness
To the chassis.
!] Lead with connector
(LVDS)
![ Press the
two hooks.
Marking is printed on the
bottom.
Hook
Remove it while
pressing the hook
of the connector.
VPL-HW40ES