Dc Fan (For Lamp); Dc Fan (For Lamp Power Supply) And Ta Board - Sony VPL-HS60 Service Manual

1-5-4. DC Fan (for Lamp)

Removal
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the C board.
(Refer to steps 3 to 6 of Section 1-4-1.)
3. Remove the lamp assembly.
(Refer to steps 2 and 3 of Section 1-5-2.)
4. Remove the lamp power supply unit.
(Refer to step 4 of Section 1-4-6.)
5. Remove the optical block assembly.
(Refer to step 5 of Section 1-5-3.)
6. Remove the two screws (BTP3 x 12), then remove the
lamp house.
7. Remove the two screws (BTP3 x 12), then remove the
DC fan (for lamp).
8. Remove the two screws (BVTP3 x 6), then remove
the thermostat.
Lamp house
Thermostat
BVTP
3 x 8
Installation
9. Attach the DC fan (for lamp) in the reverse order of
steps 5 to 7.
10. Assemble this unit in the reverse order of steps 1 to 4.
VPL-HS60/HS51A
1-5-5. DC Fan and TA Board
Removal
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the C board.
3. Remove the lamp assembly.
4. Remove the lamp power supply board.
5. Remove the optical block assembly.
6. Remove the two screws (BVTP3 x 20), then remove
7. Remove the five screws (BTP3 x 12), then remove the
8. Remove the two screws (PTP4 x 45), then remove the
9. Remove the screw (BTP3 x 12), then remove the TA board.
BTP
BTP
3 x 12
3 x 12
DC fan
(for lamp)
Installation
10. Attach the DC fan and TA board in the reverse order
11. Assemble this unit in the reverse order of steps 1 to 5.
(Refer to steps 3 to 7 of Section 1-4-1.)
(Refer to steps 2 and 3 of Section 1-5-2.)
(Refer to step 4 to 10 of Section 1-4-6.)
(Refer to step 5 of Section 1-5-3.)
the fan cover (B) and DC fan (Sirocco) [A].
duct (panel).
DC fan (sirocco) [B].
BVTP3 x 20
BTP
3 x 12
Duct
(panel)
DC fan
(sirocco)
[B]
of steps 6 to 9.
Fan cover (B)
DC fan (sirocco) [A]
TA board
BTP
3 x 12
PTP4 x 45
1-13