C Board-2 And U Board - Sony RM-PJ25 Service Manual

1-3-7. C Board-2 and U Board

3 Front cover assembly
Place the harness at a right
angle as shown in the figure.
Harness
VPL-HW40ES
4 Four screws
(PSW4 x 16)
2 Four screws
(BVTP3 x 12)
1 Lens cap
Note in operation:
Do not damage the harnesses.
GA board
Lead with connector (LVDS)
CN600
CN301
CN602
Marking is printed on the top. CN400
6 Optical unit block (C board)
7 Screw
(BVTP3 x 12)
CN70 8 U board
5 Two dowels
When installing the harness,
the harness should not protrude
exceeding the shaded area.
G board holder block
Hooks of plate clamp
Hooks of bottom cover
assembly
Harness of the lead with connector
(LVDS) should not override on top
of the chassis screw.
QA board
CN1001
CN301
Front side
Lead with connector
(LVDS)
Chassis screw
Tape
Chassis
1-9 (E)