Troubleshooting; Technical Specifications - Tennant V-WD-24P Operator's Manual

EN

TROUBLESHOOTING

Problem
Machine does not run
Machine has little or no
suction

TECHNICAL SPECIFICATIONS

Voltage/Frquency
Current
Max Airflow
Max Water lift
Tank Capacity
Power cord length
Net Weight
Sound pressure level [dBA]
Protection
Pump flow rate at listed discharge height:
Pump Discharge elevation
0 m / 0 ft
1,52 m / 5 ft
3,05 m / 10 ft
4,57 m / 15 ft
6,10 m / 20 ft
7,62 m / 25 ft (MAX)
12 TENNANT V-WD-24P
Cause
ON/OFF switch is off
Machine not plugged to wall outlet
Faulty on/off switch
Faulty power cord
Faulty vacuum motor
Faulty pump
Hose is clogged
Holes in hose
Intake is clogged
Head is not securely latched
Worn gasket which is leaking air
Tank or bag are full
Drain hose cap is loose
V-WD-24P
120 V, 60 Hz
8.5 A + 5.9 A receptacle
200 m
2530 mm H
90 L; 23,78 Gal
0.4+12 m; 1.3+39.4 ft
58.43 lb / 26,5 kg
70,0 dBA
IPX4
Flow Rate
181,7 l/min / 48 GPM
166,6 l/min / 44 GPM
151,4 l/min / 40 GPM
136,3 l/min / 36 GPM
87,06 l/min / 23 GPM
60,57 l/min / 16 GPM
Solution
Turn switch to on
Plug power cord to wall outlet
Contact service center
Contact service center
Contact service center
Contact service center
Clear hose
Replace hose
Remove
obstruction
Latch both hooks down securely
Inspect all gaskets, replace if
necessary
Empty tank or bag.
Tighten cap
/h; 117,72 cfm
3
O; 99.6" H O
2 2
hose and clear