Mode 3: Emptying A Flooded Area; Dry Vacuuming - Tennant V-WD-24P Operator's Manual

EN
on and off depending on the water level
keeping the tank empty.
MODE 3: EMPTYING A FLOODED
AREA
1. Connect the pump drain hose (not
included) to rear of machine and route the
drain hose to the draining area.
2. Turn on the motor switch and pump switch.
3. Start picking up water. After a while, the
pump will start emptying the tank.
4. Place the vacuum hose under the water
level in order to pick up only water.
5. Turn off the motor switch. The vacuum
pressure created inside the tank from the
pump will provide a continuous water flow.
The flow will stop when machine begins to
pick up air mixture.

DRY VACUUMING

WARNING - This machine has been
designed to work as a wet & dry
vacuum cleaner. Dry operation is
allowed only with the optional dry kit
correctly installed, as specified in this user
manual.
Kit Part Number KTRI05593 (see page 7)
Warning:
appliance, the device must be
correctly assembled. Check that all
the equipped filtering elements are in place
and efficient.
1. Remove float valve from motor head.
2. Position the filter holder ring on the motor
head and lock it by rotating it clockwise..
10 TENNANT V-WD-24P
Before using
3. Place filter cartridge into the 3 gaps. Lock
it into position with filter holder.
Make sure to correctly place cartridge filter.
NO
4. Mount the microfiber bag on the deflector.
Be careful that the bag does not cover the
top of the pump.
the
5. Insert the double filtration system into the
tank.
6. Mount the head on top of tank and lock it
with latches.
7. Press on/off switch and operate tools as
normal.