Recommended Stock Items; Troubleshooting - Tennant V-BP-10 Operator And Parts Manual

OPERATION
4. Once a month (or more often if necessary) clean
the dome filter, located inside the vacuum
underneath the Micro and cloth filters
a. Pull the top piece of the dome filter off and
remove the foam media (Figure 10). Shake it
out, rinse it and let it air dry thoroughly.
FIG. 10
b. Before the next use, return the foam media to
its place. Replace with new foam media if
necessary.
c. Firmly snap the top piece of the dome filter
into place.
NOTE: If using a high filtration disc in place of the
foam media, check it every 2- -3 weeks. When the disc
becomes discolored, replace it with a new disc. The
life of the high filtration disc will depend greatly on the
use and care of the Micro filter and cloth filter.

RECOMMENDED STOCK ITEMS

Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
8
Home Find... Go To..

TROUBLESHOOTING

1. If the vacuum will not operate, check:
a. The power supply cord at the wall outlet.
b. The power supply cord at the vacuum.
c. That the switch is in the "on" position and
functioning properly.
2. If the pigtail (18" power cord) is getting warm,
check to see that the extension cord does not
exceed a length of 50 feet at 16 gauge or 100 feet
at 14 gauge. Longer cords will overheat and
damage the vacuum.
3. If the exhaust that comes out of the bottom of the
vacuum is warmer than usual, check and/or clean
all four filters.
4. If the power switch fails, check the circuit breaker.
If that is not the problem, see an authorized
servicing dealer.
5. If loss of suction occurs:
a. Check that debris is not plugging the hose,
wand, and/or floor tool.
b. Check and/or clean both micro and cloth
filters.
c. Check that the hose cuffs are fitting tightly on
the hose and are not cracked.
d. Check that the cap is properly attached to the
body.
V- -BP- -10 (09- -10)