Main Menu  Op Mode Set; Main Menu  Console; Main Menu  Lcm Passwd Prot; Main Menu  Reset Btn Prot - Moxa Technologies NPort 5600-8-DT Series User Manual

NPort 5600-8-DT/DTL Series
Main Menu  Op Mode set
Under Op Mode set, you can view or modify each device port's operation mode. You will first select the port
that you wish to modify or view. Note that you can only select the operation mode. You will not be able to view
or modify the advanced operation mode settings through the LCM console.
Main Menu  Console
Under Console, you can enable or disable the web and Telnet consoles. The following fields are displayed:
• Web console
•

Telnet console

Main Menu  LCM passwd prot
LCM passwd prot refers to password protection for the LCM. If password protection is enabled, users will be
required to enter the password in order to use the LCM console.
Main Menu  Reset btn prot
Reset btn prot refers to reset button protection. If reset button protection is enabled, you will only be able to
use the reset button in the first 60 seconds after powering on the NPort. After 60 seconds, the reset button will
be disabled.
Main Menu  Ping
You can use the built-in Ping function to verify network operation. Enter the IP address that you wish to ping
and check the LCD screen for the response.
Main Menu  Save/Restart
If any configuration changes are made through the LCM, you will need to Save/Restart for the changes to
take effect.
Telnet Console
You can use Telnet to open a terminal session with the NPort 5600-8-DT/DTL over one of the Ethernet ports.
Simply Telnet to your device server's IP address. You will be presented with a text menu displaying the NPort
5600-8-DT/DTL's general settings, which you will be able to view and modify. Please refer to Chapter 4 for a
description of the available settings.
If you are unable to connect to the Telnet console, it may be because it has been disabled through the LCM
console.

Serial Console (NPort 5600-8-DT)

You can connect to the serial console port to open the serial console. Connect to the console port with a
serial-based terminal or terminal emulator program, such as Windows HyperTerminal. You may also download
PComm Lite at www.moxa.com. The terminal type should be set as ANSI or VT100, and the serial
communication parameters should be set as 19200, 8, N, 1 (19200 for baud rate, 8 for data bits, None for
parity, and 1 for stop bits). As soon as the connection is open, you will be presented with a text menu displaying
the NPort 5600-8-DT's general settings. Please refer to Chapter 4 for a description of the available settings.
www.ipc2u.ru
Other Configuration Interfaces
10-3
www.moxa.pro