Pinout Information for MAX 10 FPGA I/O
Pinout Information for MAX 10 FPGA I/O
Pinout Information for MAX 10 FPGA I/O
3.7 Boot Select
3.7 Boot Select
3.7 Boot Select
Jumper J3 is used to strap the MAX 10 FPGA device's BOOT_SEL pin. The 10M08 device supports holding two FPGA
Jumper J3 is used to strap the MAX 10 FPGA device's BOOT_SEL pin. The 10M08 device supports holding two FPGA
Jumper J3 is used to strap the MAX 10 FPGA device's BOOT_SEL pin. The 10M08 device supports holding two FPGA
images is its Configuration Flash Memory. The BOOT_SEL pin can be used to allow the user to select which image is
images is its Configuration Flash Memory. The BOOT_SEL pin can be used to allow the user to select which image is
images is its Configuration Flash Memory. The BOOT_SEL pin can be used to allow the user to select which image is
loaded by default on power up.
loaded by default on power up.
loaded by default on power up.
BeMicro Max 10 Getting Started User Guide, Version 14.0
BeMicro Max 10 Getting Started User Guide, Version 14.0
BeMicro Max 10 Getting Started User Guide, Version 14.0
23
23
23