Reset To Factory Settings; Emptying The System - Nespresso Prodigio Instruction Manual

Reset to Factory Settings /

If you reset to factory settings,
Min 5 sec
this will cancel the pairing, reset
the capsules stock management
and the descaling alert.
恢复出场设置将导致取消蓝牙
连接，复位咖啡库存管理和除
垢报警。

Emptying the System

清空系统 ： 如将长时间不使用或需要防止结霜
To note, the machine remains blocked for 10 minutes after emptying!
请了解，清空系统后机器会锁定10分钟，期间不能进行任何操作。
❶
Remove the water
Place a container under
the coffee outlet.
移走水箱
在咖啡出口下方放置一
个容器。
❶
Factory settings are:
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at
least 5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer
to the «Troubleshooting section».
before a period of non-use or for frost protection /
❷
tank. Ensure the machine
> 6 sec
is ON, press and hold
the Ristretto & Lungo
buttons together for at
least 6 seconds.
确保机器在开机的状
态，同时并持续按住
芮斯崔朵和大杯咖啡
按键至少6秒钟。
恢复出场设置
出场设置参数：
- 大杯咖啡，浓缩咖啡和芮斯崔朵咖啡杯量分别为
110ml / 3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- 9分钟后自动关机模式。
- 水硬度设置恢复默认值，相当于1000杯浓缩咖
啡的水量。
恢复出场设置操作前需要先：
1. 确保机器在关机状态。
2. 持续同时按住浓缩和大杯咖啡按键至少5秒钟。
所有咖啡按键指示灯和LED灯将闪烁一次表示设
置成功。如需解除配对，请参考"故障排除"章节。
❸
芮斯崔朵和大杯咖啡按键闪烁表示进入清空模式。然后关闭
滑盖开始清空。如果滑盖已经处于关闭状态，清空流程会自
动开始。结束后，清洗滴水盘和杯托
结束后机器会自动进入关机模式。
The Ristretto and Lungo coffee buttons
will flash for confirmation. Then close the
slider to start procedure. If the slider was
already closed, the emptying process starts
automatically. When the procedure is finished,
clean the drip tray and the cup support.
Machine turns to OFF mode automatically
when empty.
EN
CN
19