Standby Function - Lovato T-FIRE MODUL Assembling Instructions And Maintenance

1.
ON/OFF
The ON/OFF of the controller is through the prolonged pressure of the button K1
The OFF state is signalled with the blinking led OFF
2.
Visualizations
Normally the display shows sensor 1 temperature.
The sensor 2 temperature is showed by the prolonged pressure of K1
3.
ALARM Function
If the temperature read by the sensor is over the value Alarm Thermostat (A90°C)
The acoustic and visual signal is activated
SILENCE Function: the acoustic signal can be deactivated for 5 minutes pushing any
button. If the alarm condition remains the acoustic signal starts again
4.
ANTI FREEZING Function
If the temperature read by the Sensor is lower than the value of the Anti Freezeing Thermostat (3°C)
The Pump P1 is activated and the display shows ICE
5.

STANDBY Function

If the system is OFF, in condition of ALARM or ANTI FREEZING
The device starts ON
6.
ANTI BLOCK Pump Function (P1 and P2)
If the pumps are OFF for a time over the Anti Block Timer t01 (also in STANDBY Status)
The Pumps are activated for T02 seconds and the display shows bLP
7.
Pump TEST Function P1
Through a prolonged pressure of the button K2
The Pump P1 is activated for the time of the button's pushing and the display shows tSt
8.
Pump TEST Function P2
Through a prolonged pressure of the button K3
The Pump P2 is activated for the time of the button's pushing and the display shows tSt
Assembling instrunctions and maintenance
39