Current Orbit Marine IC PRO LED Safety Instructions page 5

LOOP IC Remote Control Overview
®
SET ON OFF
CLOCK
TIME TIME
H
HOUR MINUTE
WEATHER
-
+
%
H
CLEAN
1 2 3
STREAM SURGE WAVE
FLOW
FLOW FREQ
®
current-usa
Wave Pump Programming
Pump 1 - press to program the primary eFlux wave
1
pump #1
Pump 2 - press to program the secondary eFlux wave
2
pump #2
Pump 3 - press to program pump #3. NOTE: Pump#3
3
is only programmable in STREAM mode (no wave mode)
Primary/Secondary - press to designate if Pump#2 is a
P/S
primary or secondary pump (anti-sync with Pump#1)
Pump Power On/OFF - press to turn all pumps ON or OFF
STREAM Mode - press to program designated pump into
STREAM
stream/constant flow mode
WAVE Mode - press to program designated pump into
WAVE
wave/short pulse flow mode
SURGE Mode - press to program designated pump into
SURGE
surge/long on/off flow mode
FLOW Increase - press to increase the flow rate/impeller
speed from 0-100%
FLOW
FLOW Decrease - press to decrease the flow rate/impeller
FLOW
speed from 0-100%
Frequency Increase - increases the frequency/time
interval in Surge & Wave Modes
FREQ
Frequency Decrease - decreases the frequency/time
FREQ
interval in Surge & Wave Modes
Light Power ON/OFF - press to turn light fixture and Main IC controller on or off
SET Set time of day - press to set the 24:00 clock/current time of day
CLOCK
ENTER
RESUME
ON
ON TIME - press to program time light should begin to turn ON each day
TIME
M
OFF
OFF TIME - press to program time light should begin to turn OFF each day
TIME
HOUR / + - press to adjust the Hours or adjust weather forecast % up (+)
HOUR
+
MINUTE / - - press to adjust the Minutes or adjust weather forecast % down (-)
MINUTE
_
FEED
ENTER/RESUME - press to enter a setting or to re-enter back into normal program
ENTER
RESUME
DAYLIGHT - press to program color spectrum to run during the day
SUNRISE/SUNSET - press to program the color spectrum to run during sunrise/sunset
P/S
OFF TIME - press to program the color spectrum to run during the night
FREQ
M
Custom Color - press to program a custom color to use on-demand (Color Memory)
LOCK
WEATHER - press to the daily weather forecast or turn off daily weather
WEATHER
%
LOCK/UNLOCK - press to lock settings and all remote functions, press again for 5
LOCK
seconds to unlock settings and remote functions
Color Spectrum Adjustment
Dynamic Modes
FEED Mode - runs feed program, 10 min duration
FEED
Lights: Remain in current color mode
Pumps 1 & 2: reduce flow to 0%
Pump 3: reduce flow to 0%
Note: Any eFlux DC flow pumps connected to the network
will reduce flow to 30%
LUNAR - press to run light in lunar mode:
Blue: 100%, White: 0%, Red 0%, Green: 0%
Lunar Cloud - press to run night cloud cover
(blue moonlight fades)
CLEAN Mode - runs clean mode, Duration: 30 min
CLEAN
White: 100%, Red: 100%, Green: 100%, Blue: 0%
Rolling Clouds - runs rolling cloud program
Random Clouds - runs random cloud program
Lightning - runs lightning program
Full Thunderstorm - runs full thunderstorm program
Page 5
Installation Instructions