Temperature Control; Memory Screen; Clean Cycle Screen; Settings Screens - HotSpring Highlife Series Owner's Manual

TEMPERATURE CONTROL

Press the actual temperature on Home screen to
display Set Temperature screen.
The factory set temperature of the spa water is 100°F (38°C).
The last temperature value set by the user will be stored in memory. If
power is disconnected from the spa, it will automatically revert to the last
set temperature when power is reapplied.
Press to raise set temperature of spa. Press and hold to
raise the temperature continuously.
Press to lower set temperature of spa. Press and hold to
lower the temperature continuously.

MEMORY SCREEN

Press on Home screen to display Memory screen.
Press to activate the last saved set of operating
functions.
Press to save the current set of operating
functions (jets and lights only).
Press to return to home screen if neither of the
above buttons are used. Screen will automatically
revert back after 10 seconds of non activity.

CLEAN CYCLE SCREEN

Press on Home screen to display Clean Cycle screen.
Press & hold to activate and deactivate the Auto
Clean Cycle. If activated, a clean cycle will run
every 24 hours starting at the time ON was first
pressed (runs Jet 2 for 1 minute and Jet 1 for 9
minutes).
Press to return to Home screen. Screen will
automatically revert back after 10 seconds of non
activity.
Operating Instructions
The set temperature range is from
80°F to 104°F (26°C to 40°C).
NOTE: The water temperature
may vary depending on the current
use and condition of your spa and
outside temperatures.
Press to start
the manual Clean Cycle. The
screen will briefly display CLEAN
CYCLE: ACTIVE. Activates jet
pump 1 on high speed for a ten
minute period.

SETTINGS SCREENS

Press on Home screen to display first Settings Screen.
TEMPERATURE LOCK
Press on Home screen to display Temperature Lock.
SPA LOCK
Press on Home screen to display Spa Lock.
SUMMER TIMER
Press on Home screen to display Summer Timer.
will remain on for approximately 5 minutes pushing water through
the heater to cool it down.
• Both heater and circulation pump will remain off for eight hours.
The circulation pump and heater will automatically shut down
for the same eight hours every day until the Summer Timer is
Page 14
deactivated.
• It is recommended to activate the Summer Timer in the morning so
that the spa is off during the hottest part of the day and so that the
circulation pump will start up again in the evening when you are
ready to enjoy the spa.
The first Settings screen allows
you to turn Temperature Lock,
Spa Lock, and Summer Timer On
or Off.
The Temperature Lock feature
prevents changing the desired
water temperature setting. All
other control panel functions
will operate normally while the
Temperature Lock is "ON".
Press and hold ON or OFF for
approximately 4 seconds to activate
or deactivate.
When activated, the Spa Lock
feature disables all functions on
the control panel.
The control panel will not
respond to anything except
on the Home screen.
Press and hold ON or OFF for
approximately 4 seconds to activate
or deactivate.
• The Summer Timer can be
activated during extremely hot
summer months to help maintain
set water temperatures.
• Activating the Summer Timer
causes the heater to immediately
shut down. The circulation pump
Press ON or OFF to activate or deactivate.
Page 14