Preparations; Before Lifting Century Out From The Pallet; Placing The Century Into Its Correct Position; Assemble The Floor Fixtures - Arjohuntleigh Century Assembly And Installation Instructions Manual

Preparations

CAUTION!
During the unpacking of this product,
always make sure that ALL staples are
fully removed when removing the outer
cover. This will prevent damage to the
laminate surface.
Remove the wooden lid and then the box
covering the product.
Placing the Century into its
correct position
Unpack the Century and put it in correct
place according to:
• Drainage
(See section Drain Installation),
• water supply
(See section Water Installation) and
• against a wall.
Place the Century by lifting in the upper
part of the door opening, one person at
each side of the tub. (See Fig. 1)

Assemble the floor fixtures

1 Place the floor fixtures (included in
delivery) against the two rear legs, as
shown in the illustration.
(See Fig. 2)
2 Using the floor fixtures as templates,
mark the location of the feet and of
the four mounting holes on the floor.
(See Fig .3)
Remove the floor fixtures and save
them for the mounting.
(See section Mounting of floor
fixtures.)
Move the Century out from the wall.
Before lifting Century out from
the pallet
Prior to moving the bath into its final
position, check:
• Water service, stop and mixing
valves, lines, spout etc.
1
2
3
• House drain system ready for
hook-up.
• Provision is made for electrical
service to interior junction box.
5