Appendix G Factory Default / Configuration Sheets; Cm 2000 Control Module V2.35 Configuration Sheet - nvent RAYCHEM T2000 Installation, Operating And Maintenance Manual

APPENDIX G FACTORY DEFAULT / CONFIGURATION SHEETS

G.1 CM 2000 CONTROL MODULE V2.35 CONFIGURATION SHEET
78 | nVent.com
= Most commonly changed setting
IMPORTANT: It is recommended that the HTC console units be selected before any other
settings are entered.
Temperature Configuration Parameters
Parameter Factory
Setpoint Temp 68°F (20.0°C)
High TS 1 Temp Enable
High TS 1 Temp 212°F (100.0°C)
Low TS 1 Temp Enable
Low TS 1 Temp 14°F (–10.0°C)
TS 1 Failure Enable
High TS 2 Temp Disable
High TS 2 Temp *n/a
(212°F (100.0°C))
Low TS 2 Temp Disable
Low TS 2 Temp *n/a
(14°F (–10.0°C))
TS 2 Failure Disable
Control TS Failure Enable
Temp Alarm Mode Latching
Alarm Configuration Parameters
Parameter Factory
High Load Current Disable
High Load Current *n/a (30.0 A)
Low Load Current Enable
Low Load Current 1.0 A
High GF Current Enable
High GF Current 50 mA
GF Trip Current Enable
GF Trip Current 75 mA
High Voltage Enable
High Voltage 270 V
Low Voltage Enable
Low Voltage 90 V
Overcurrent Trip Enable
Switch Failure Enable
HTC Reset Disable
C.B. Limiting Disable
Power Limiting Disable
Switch Limiting Disable
EEROM Data Failure Disable
Alarm Output N.O.
Flash Alarm Output No
User
User