Removing The Air Intake Duct; Figure 3-4 Removing The Air Intake Duct - Xantrex GT100 Series Planning And Installation Manual

Removing the Air Intake Duct

153379
The Air Intake Duct may be removed from the rear of the GT100 enclosure if it is
necessary to move the inverter through a standard 36-inch door opening and into
location.
To remove the GT100 Air Intake Duct:
1. Remove and save the 8 mm nuts (11 total) that attach the Air Intake Duct to
the rear of the GT100 enclosure.
2. Carefully remove the Air Intake Duct.
3. Once the GT100 is moved and installed, replace the Air Intake Duct, and
tighten the 8 mm nuts (11 total).

Figure 3-4 Removing the Air Intake Duct

Important:
Before proceeding with the installation, determine the location and layout
of the components, conduit penetration locations, conductor and conduit sizing, and
method for anchoring the unit. Ensure adequate space is provided for clearance for
ventilation and serviceability. Review Chapter 2, "Planning" if necessary before
proceeding.
This manual for use by qualified installers only
Unloading
Air Intake Duct
8 mm nuts (11 total)
3–5