Table of Contents
Advertisement
INF-MOTWALL / XSD1U
Assembly And Installation
The INF-MOTWALL / XSD1U can be to be mounted to:
•
a bare concrete wall with a minimum thickness of
8" (203mm):
•
a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall;
•
wood studs spaced 16" or 24" on center with a
maximum drywall covering of 5/8"; or
•
a 2" x 4"-25ga minimum steel stud wall.
•
a 1/2" minimum thickness plywood-backed, steel
stud wall covered with drywall having a maximum
thickness of 5/8".
Installing to Wood Stud Wall
1.
Use a stud-finder to locate 16" or 24" studs.
2.
Place top bracket (B) against wall at desired mounting
location 10 1/8" above the desired center of the screen. Use
a level to ensure a level mount. (See Figure 1)
3.
Mark hole locations at each mounting location in the center
of each stud. (See Figure 1)
4.
Drill two 7/32" holes at marked hole locations. (See Figure 1)
5.
Install two 5/16 x 2 1/2" hex head cap screws (G) through
two 5/16" washers (H), holes on top bracket and into drilled
holes on wall. (See Figure 1)
(G) x 2
5
(H) x 2
(B)
Figure 1
CAUTION:
Use proper lifting techniques and two people to
install INF-MOTWALL / XSD1U assembly onto wall!
6.
Carefully hang INF-MOTWALL / XSD1U assembly (A) onto
top bracket (B), making sure mount slides behind upper
flange on top bracket (B). (See Figure 2)
8
3
4
7/32" (5.3mm)
(A)
Figure 2
7.
Remove screw holding bottom cover to INF-MOTWALL /
XSD1U assembly (A) and remove bottom cover. (See
Figure 3)
7
7
Figure 3
8.
Mark hole locations for lower two mounting holes. (See
Figure 4)
9.
Remove mount (A) from top bracket.
10. Drill two 7/32" holes at marked hole locations. (See Figure 4)
x
8
Figure 4
Installation Instructions
6
(B)
6
7
x
7/32" (5.3mm)
10
Advertisement
Table of Contents
