Table of Contents
Advertisement
INF-MOTWALL / XSD1U
Site Requirements (Steel Studs without Plywood Backing)
16" (on center) Studs
INF-MOTWALL / XSD1U Installation Location
(Must be centered over two studs)
If back side of wall is unfinished, drywall must be installed
to a minimum of one stud left and right of the studs
being used to install the mount. Drywall must be
secured to studs with screws 12" on center
Drywall
**1/2" minimum
Drywall Thickness
(Both Sides of Stud)
**See hazard statement
on page 2!
12
FRONT
Steel Stud (2 x 4 / 25ga minimum)
Stud type and structural strength must conform to the North American
Specification for the Design of Cold-Formed Steel Structural Members.
[362, 125 18, C-Shape, S - Stud Section]
Figure 13
Installation Instructions
There must be a minimum of
1-7/8" (48mm) clearance
inside wall
Advertisement
Table of Contents
