Table of Contents
Advertisement
I. Timing/Dialing Options
There are six positions in the timing/dialing options. To program these options, enter the six desired timing/dialing numbers followed
by #18. The six available timing/dialing options are defined as follows:
Factory Default Setting: 2 + 3 + 0 + 3 + 2 + 1
Talk/Listen Delay
Call Length
Silence Time Out
Dial Next Number on Ring No Answer
Dial Next Number on Busy
Future Use (set to 1)
Setting A - Talk/Listen Delay
This feature selects switching time between talk and listen modes (VOX switching time). Use chart below-left.
Factory Setting: 0.2 seconds
Setting B - Call Length Time Out
This feature selects the maximum length of time that calls can be connected. Programmable in increments of 1 minute up to a
maximum of 9 minutes (Touch Tones 1 - 9). Program 0 in this location to disable the call length time out. With the call length
disabled, the PB-3 phone must rely on a CPC signal, busy signal, silence or return to dial tone to hang-up. Use chart below -
center. Factory Setting: 3 Minutes
Setting C - Silence Time Out
This feature selects the length of time that calls will remain connected without voice activity. Programmable in increments of 10
seconds up to a maximum of 90 seconds (Touch Tones 1 - 9). To disable the silence time out, program 0 in this location. Use
chart below - right. Factory Setting: Disabled
Touch Tone
Talk/Listen Delay
1
0.1 seconds
2
0.2 seconds
3
0.3 seconds
4
0.4 seconds
5
0.5 seconds
6
0.6 seconds
7
0.7 seconds
8
0.8 seconds
9
0.9 seconds
Setting D - Dial Next Number on Ring No Answer
If enabled and a ring-no-answer is detected, the PB-3 phone will dial the next
programmed speed dial number, and continue to cycle through the emergency
numbers until a call is completed.
Factory Setting: Redial if not answered after 3 rings
Setting E - Dial Next Number on Busy
If enabled and a busy is detected, the PB-3 phone will dial the next programmed
speed dial number, and continue to cycle through the numbers until a call is
completed.
Factory Setting: Enabled Note: If the busy signal is interrupted with a promotional
message, contact your central office to have it removed.
Setting F - Future Use (set to 1)
(memory location #18)
Dial: A + B + C + D + E + F + # + 1 + 8
Touch Tone
0
1
2
3
4
5
6
7
8
9
Call Length Time Out
Disabled
1 minute
2 minutes
3 minutes
4 minutes
5 minutes
6 minutes
7 minutes
8 minutes
9 minutes
6
Enter Timing/Dialing Settings Here:
A
B
C
D
E
F
Touch Tone
Silence Time Out
0
Disabled
1
10 seconds
2
20 seconds
3
30 seconds
4
40 seconds
5
50 seconds
6
60 seconds
7
70 seconds
8
80 seconds
9
90 seconds
Touch Tone
Setting D
1 or 0
Disabled
Dials second number after 2, 3,
2, 3, 4... 9
4...9 rings respectively
Touch Tone
Setting E
1
Disabled
2
Enabled
#18
Advertisement
Table of Contents
