How To Use Solaris System Information Commands - Sun Microsystems Sun Fire V490 Administration Manual

If you want to change RSC configuration, run the configuration script again as
shown in Step 1 of this procedure.
For information about RSC configuration, user accounts, and alerts, see:
Sun Remote System Controller (RSC) User's Guide
This document is included on the Sun Fire V490 Documentation CD.
How to Use Solaris System Information
Commands
This section explains how to run Solaris system information commands on a Sun
Fire V490 server. To find out what these commands tell you, see "Solaris System
Information Commands" on page 93, or see the appropriate man pages.
Before You Begin
The operating system must be up and running.
What to Do
1. Decide what kind of system information you want to display.
For more information, see "Solaris System Information Commands" on page 93.
2. Type the appropriate command at a console prompt. See
TABLE 11-1
Command What It Displays
System configuration
prtconf
information
Diagnostic and configuration
prtdiag
information
Using Solaris Information Display Commands
What to Type
/usr/sbin/prtconf
/usr/platform/sun4u/sb
in/prtdiag
.
TABLE 11-1
Notes
—
Use the -v option for
additional detail.
Chapter 11 Monitoring the System 197