sauter TB Series Instruction Manual

DIGITAL COATING THICKNESS GAUGE
Models: TB 1000-0.1 F
TB 1000-0.1N
TB 1000-0.1FN
TB 2000-0.1F
Table of contents
1. Features
2. Specifications
3. Front panel descriptions
4. Measuring procedure
5. OFFSET-Accur function
6. Calibration
7. Battery replacement
8. Calibration foils
9. Correct handling of coating thickness
measurement with external sensors
10. Considerations/ Trouble-shooting
11. Declaration of conformity
Annotation: It is strongly recommended to calibrate
the new instrument before the first use, as
described in paragraph 6. By doing this it
will be achieved a much better measure-
ment result right from the start.
1. Features
* The instrument meets ISO standards 2178. So it can
be used in laboratory conditions as well as
under "harsh field" conditions.
* The instrument is widely used to measure the thickness
of these nonmagnetic coatings: paint, plastic & PVC,
porcelain enamel, copper, zinc, aluminium, chrome,
layers of laquer, layers of paper etc.
These coatings may be put up on following magnetic
base grounds: steel, iron, nickle, etc.
* Wide measuring range and high resolution
2. Specifications
Display: 4 digits, 10 mm LCD
TB-BA-e-1212
Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: info@sauter.eu
Instruction Manual
TB
Range:
Resolution:
Accuracy:
Following accuracy is given for the models TB 1000-0.1F,
TB 1000-0.1N as well as TB 1000-0.1FN:
- Standard: 3% of the measured value or min. ± 2.5 µm
Is valid within a tolerance range of ± 100 μm around the
individually measured range, if a two-point calibration was
performed within this tolerance range.
For model TB 2000-0.1F accuracy is:
- Standard: 5% of the measured value or min. ± 2.5 µm
Is valid within a tolerance range of ± 100 μm around the
individually measured range, if a two-point calibration was
performed within this tolerance range.
- Off-Set Accur Mode: 1% of the measured value
Is valid within ± 50 μm around the Off-Set Accur point.
All tolerances are valid after the adjustment procedure!
Power supply:
Operating conditions:
Size:
Weight:
Accessory:
3. Front panel description
3-1 Sensor
3-2 Display
3-3 Zero- key
3-4 Plus- key
3-5 Minus- key
3-6 Power- on/ Power- off key
3-7 µm/ mil key
3-8 Battery compartment/ cover
Tel: +49-[0]7433-9933-199
Fax: +49-[0]7433-9933-149
Internet: www. sauter.eu
1000 μm and 2000µm
0.1 μm to 100 μm
1 µm over 100 µm
or min. ± 1.0 µm
4 x 1.5V AA battery
Temperature 0 to 50 °C
≤ 80 %
Humidity
161 x 69 x 32 mm
about 260 g (including batteries)
Carrying case
Operation manual
Instrument and sensor
Calibration foils
Base plate
1