Pentair Pool Products Nocchi R4TE Use And Maintenance Manual page 28

error
Over voltage error
E05
Under voltage error
E06
temporary
Under voltage error
E07 definitive
Over voltage error
E08
temporary
Over voltage error
E09
definitive
Absence of network
E10
power (in memory)
Power error
E11
Power error
E12
Configuration error
E13
56
the control board
communication with the power part.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.).
This error occurs when
current absorbed by the module is
greater than triple the nominal
current.
This condition can be caused
when the pump is blocked by
foreign bodies.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This error condition occurs when
the voltage is 10% less than the
nominal voltage (230V).
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This error occurs when
temporary under voltage condition
is repeated 5 times e.
This error condition occurs when
the voltage exceeds by 10% the
nominal voltage (230V).
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
A definitive over voltage error
occurs after a temporary over-
voltage error is repeated 5 times.
This condition occurs following a
network absence.
This condition indicates a motor
power absorption error in terms of
its running status
This condition indicates a motor
power absorption error in terms of
its running status
This error occurs when the control
board cannot
communicate with the power part.
Page 26 of 27
26
26 - GB -
cannot the LINE Led switches off and
after which turn power back on.
If the error condition occurs again,
contact your nearest assistance
centre.
the
Cut off the power supply and wait
for the LINE Led to switch off.
Check the pump freely rotates
and if necessary remove foreign
bodies that
functioning.
Turn power back on.
If the error persists, contact your
nearest assistance centre.
Press the button START/STOP or
cut the power off and wait until the
LINE Led switches off and after
which restart the system.
If the error occurs again, contact
your nearest assistance centre.
the
In this case, the module will
attempt to
functioning after 1 minute and will
repeat the procedure up to five
times. Press
START/STOP or cut the power off
and wait until the LINE Led
switches off and after which
restart the system. If the error
occurs again,
assistance centre.
Press the START/STOP button or
cut off power and wait until the
red Led LINE goes off, then
power again to reset the system.
If the error occurs again, contact
your nearest assistance centre.
Press the START/STOP button or
cut off power and wait until the
red Led LINE goes off, then
power again to reset the system.
If the error occurs again, contact
your nearest assistance centre.
Press the button START/STOP or
correctly cut the power off and wait until the
LINE Led switches off and after
block correct
restart normal
the button
contact the