Pentair Pool Products Nocchi R4TE Use And Maintenance Manual page 23

Minimum Parameter defining minimum motor rotation frequency.
frequency
INF F
Maximum Parameter defining maximum motor rotation frequency.
frequency
SUP F
Reactivity factor Parameter defining the speed with which the motor responds to
changes in pressure. The lower the setting the faster the motor's
response.
ANP F
Bottom scale Parameter defining the sensor at the bottom of the scale. (in bar).
sensor Depends on the type of sensor applied.
SUP S
Zero sensor Minimum value read by the sensor (zero).
INF S
Use to enter an offset value for the pressure sensor. Depends on
Offset sensor
the type of sensor applied.
OFF P
Switching off time Interval of time during which pressure must remain stable (+/- 0.1
Bar) with a rotation lower than the average switching off frequency
+ 10 to trigger the motor shutdown cycle (seconds).
SPE T
Pressure Subtract this figure from the set point to obtain pressure when the
threshold motor is started-up. In other words, the motor starts-up when
pressure reaches the set point value minus the threshold value
(BAR).
DIF P
Water alarm Indicates minimum system pressure, a lack of water alarm will be
pressure generated under this threshold value Set to zero to disable this
function.
ALL P
Page 21 of 22
21
21 - GB -
20 20 40
50 40 60
15 1 50
xx 1 30
0,6 0,1 10
x 0,0 99
10 3 30
0,3 0,1 0,5
0 0 1
51