Undefined error
E99
Communication
485E
error
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This
error
occurs
when
unforeseen error takes place.
This signal refers to pump units
and is indicated when the devices
are not communicating correctly.
Page 27 of 28
27
27 - GB -
which restart the system.
If the error occurs again, contact
your nearest assistance centre.
an
Wait for a few minutes. If the
signal
remains,
contact
nearest assistance centre.
x
Press
the
START/STOP or cut the
power off and wait until
the LINE Led switches off
and after which restart the
system.
x
Check the communication
cable.
If the error occurs again, contact
your nearest assistance centre.
your
button
57