Ecotronic Control System; General Information; Export Of Operational Data Via Mod-Bus Ecotronic; Function Keys - Viessmann Vitoflex RF 150 Installation And Service Instructions Manual

Vitoflex 300-RF Installation & Operating

ECOTRONIC Control System

General information

The ECOTRONIC facility control system is a decentralized
microprocessor system (CAN-BUS) developed by
Viessmann with various modules that are connected by
a data transmission line.
Its function: the ECOTRONIC records all the data relevant
to operation and controls the supply of and demand for heat.
Thus the boiler plant is continuously monitored during all
the operating phases and kept within an optimum range in
terms of emissions.
Factory settings (pre-settings): all the parameters in the
ECOTRONIC, such as set point values and switching
times, are pre-set and can be called back up at any time.
The figures for the factory settings are given in brackets
for the various parameters.

Export of operational data via mod-bus Ecotronic

The boiler control Ecotronic can be expanded with the
ECO-SED module. This module enables and operating data
transfer between a building management system (Mod-
Bus Master) and the boiler control (Mod-Bus-Slave) per
serial interface (RS232).
Please refer to the Export of operational data via Mod-Bus
Ecotronic for details.
Note: This module is optional and must be ordered separately.

Function keys

F1 (Vitoflex 300-RF Wood)
Switch WOOD operation on and off
F2 (Vitoflex 300-RF Oil)
Switch OIL operation on and off (not applicable to
North America)
F3 (Vitoflex 300-RF Parameters)
Setting parameters, set point values, the date and time
F4 (Vitoflex 300-RF Loader System)
Setting of cycle switchover, advance-flow and post-
flow times
Note: Depending on the design and setting, some menus
and texts do not appear.
F5 (Group 1)
Setting parameters and set point values
(heat distribution, Group 1)
F6 (Group 2)
Setting parameters and set point values
(heat distribution, Group 2)
F7 (Group 3)
Setting parameters and set point values
(heat distribution, Group 3)
F8 (Group 4)
Setting parameters and set point values
(heat distribution, Group 4)
Note: Depending on the design and setting, some menus
and texts do not appear.
Operation
53