Replacing The Hydraulic Pump-Drive Belt - Toro TITAN HD 2000 Series Operator's Manual

Replacing the Hydraulic
Pump-Drive Belt
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower belt; refer to
Mower Belt for Side-Discharge Mower Decks
(page 68) or Replacing the Mower Belt for
Rear-Discharge Mower Decks (page
4. Raise the machine and support it with jack
stands (Figure 101).
5. Remove the clutch stop
Figure 100
1. Clutch stop
6. Remove the idler spring from the post
101).
7. Remove the existing belt from the
hydraulic-pump-drive pulleys and the
engine pulley.
8. Install the new belt around the engine pulley and
the 2 hydraulic-pump pulleys
Replacing the
69).
(Figure 100).
g036860
(Figure
(Figure 101).
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9. Install the clutch stop
10. Install the mower belt; refer to
(page 68).
71
Figure 101
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure 100).
Belt Maintenance
g036859