Toro TITAN HD 2000 Series Operator's Manual page 78

Figure 111
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position (Figure 112).
Figure 112
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat
surface (Figure 113).
Note:
The variance should be no more than
3 mm (1/8 inch).
g014973
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater
than 3 mm (1/8 inch), replace the blade with
a new blade; refer to
for Side Discharge Mower Decks (page 78)
or Replacing the Blades for Rear Discharge
Mower Decks (page
Note:
new blade, and the dimension obtained
continues to exceed 3 mm (1/8 inch), the
blade spindle could be bent. Contact an
Authorized Service Dealer for service.
B. If the variance is within constraints, move to
the next blade.
g014974
6. Repeat this procedure on each blade.
Replacing the Blades for Side
Discharge Mower Decks
Removing the Blades for Side-Discharge
Mower Deck
Replace the blades if they hit a solid object, or if the
blade is out of balance or bent.
1. Hold the spindle shaft with a wrench.
2. Remove the blade bolt, curved washer, and
blade from the spindle shaft
78
Figure 113
Replacing the Blades
79).
If a bent blade is replaced with a
(Figure
g014973
114).