Toro TITAN HD 2000 Series Operator's Manual page 81

Figure 119
1. Blades side to side
2. Blade tip
7. Check the front-to-rear blade level
Ensure the front blade tip is lower than the rear
blade tip as shown in the block height and rake
table. If adjustment is needed, continue with this
procedure.
Figure 120
1. Blades front to rear
2. Blade tip
8. Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9. For 60-inch mower decks only:
A. Raise the deck to the transport position
(12.7 cm or 5 inches).
B. Slowly loosen the adjusting screw on the
lift-assist spring until you can remove the
screw (see Figure
Note:
Save the screw for installation.
g037879
3. Measure from the tip of the
blade to the flat surface
here.
(Figure 120).
g037880
3. Measure from the tip of the
blade to the flat surface
here.
121).
Rear discharge mower deck shown
1. Adjusting screw
2. Bracket
10. Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
122).
11. Set the height-of-cut lever to the 3 inch (76 mm)
position.
12. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
81
Figure 121
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inch).
Figure 122
Bottom view
2. Welds
g035850
(Figure
g038090