Servicing The Fuses - Toro TITAN HD 2000 Series Operator's Manual

Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
81).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
Note:
For MyRide machines, ensure that the
ground cable does not rub against the trailing
arm or lower shock mount
Figure 83
1. Ensure that the ground
cable does not rub against
the lower shock mount.
2. Ensure that the ground
cable does not rub against
the trailing arm.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts (Figure
5. Slide the red terminal boot onto the positive (+)
battery terminal.
6. Secure the battery with the rubber strap
81).
(Figure
(Figure 84).
3. Ground cable
81).
(Figure

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component and circuit for a malfunction or short.
The fuses are located on the right console next to the
seat (Figure 84).
1. To replace the fuses, pull out the fuse to remove
it.
2. Install a new fuse
g236732
1. Fuse cover
2. Fuse holder
63
(Figure 84).
Figure 84
3. Fuel-shutoff valve
g036858