Charging The Battery - Toro TITAN HD 2000 Series Operator's Manual

2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the battery as shown in

Charging the Battery

WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from the battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the chassis; refer to
Removing the Battery (page
2. Charge the battery for 10 to 15 minutes at 25 to
30 A or for 30 minutes at 10 A.
Note:
Do not overcharge the battery.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 82).
Figure
Figure 81
61).
4. Install the battery in the machine and connect
the battery cables; refer to
(page
81.
Note:
disconnected; electrical damage may occur.
g036853
1. Positive (+) battery post
2. Negative (–) battery post
g036855
62
Installing the Battery
63).
Do not run the machine with the battery
Figure 82
3. Red (+) charger lead
4. Black (–) charger lead
g000960