Adjusting The Anti-Scalp Rollers - Toro TITAN HD 2000 Series Operator's Manual

Transport-Lock Positions
1. Transport lock knob
2. L position—The
OCK
mower deck locks into the
transport position.
Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
(also the 127 mm or 5 inch cutting-height
position) as shown in
3. Remove the pin from the height-of-cut bracket
(Figure 34).
Figure 33
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
position.
OCK
RANSPORT
Figure 34.
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
1. Deck-lift pedal
2. Height-of-cut holes
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
g037050
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
35 or
position
34
(Figure 34).
Figure 34
3. Height-of-cut pin
4. Transport lock knob
Figure 36.
g036745
Figure