Audi A7 Sportback 2011
6
No. 122, Body, Edition 10.2010
–
To install the add-on components, remove the profile cap
-1- from the profile tube -5- -arrow A-.
–
Insert the add-on components in the T groove -arrow B-.
–
Slide the profile cap -1- back on -arrow C-.
When the add-on components are not in use, secure the T
groove with the profile cover -4-.
–
Adjust the profile cover -4- to the length of the roof bars
with the profile caps -1- closed.
–
Place the profile cover -4- on the T groove on the profile
tube -5- and press the cover into the T groove -arrow-.
Note
When driving with a roof load, ensure that the German
♦
Road Traffic Regulations (StVZO) or any country-specific
regulations are observed.
For reasons of convenience, it is common for the roof bars
♦
with/without add-on components to remain on the vehicle,
even if they are not in use. As a result of the increased
wind resistance, your vehicle will consume more fuel and
will produce additional noise.
We therefore recommend that you remove the roof bars
♦
after use.
Increased wind noise can result from driving with the roof
♦
bars attached.
If required, the profile cover provided can be replaced with
♦
an improved aeroacoustic version (grooved rubber) for
minimising noise (order number 4L0.071.633.A).
4.3
Removing the roof bars from the vehicle
–
Remove the load and the add-on components.
–
Open the lock using the key and open the cover flap -16-.
Note
The illustration shows the rear roof bar.
–
Unscrew the left and right tensioning bolts -13- alternately
using the torque wrench -15- until obvious resistance is
felt.
–
Slide the claw fastener -12- against the direction of travel
until the stop.
–
Detach the left and right-hand claw fasteners -12- from
the positioning bolts -X- and hook the narrow end into
installation position on the support bracket -9-.
–
Remove the roof bars from the vehicle roof.
12
4 Installing/removing roof bars on vehicle
5
4
5
16
9
12
Y
B
C
A
1
ZUB-0338
1
ZUB-0339
13
15
15
ZUB-0795