The gap -a- must not exceed 1 mm.
If the rubber supports on the support bracket housing are not
flush to the surface, we recommend that you have the width
adjustment checked by a qualified workshop
the roof bar width" on page
doing so.
–
Gently tighten the bolts -13- alternately using the torque
wrench -15-.
–
Check the position of the support base housing -A- and
claw fastener -B- and correct if necessary.
–
Tighten one tensioning bolt -13- after another using the
torque wrench -15- until the torque wrench makes an
audible clicking sound. This indicates that the correct
torque has been applied.
–
Close the cover flap -16- and close the lock -17- with the
key -18-.
Installing the front roof bar
–
Install the front roof bar in the same way as the rear roof
bar.
Note
The illustration shows the positioning bolts for the front roof
bar.
4.2
Installing add-on components
–
Secure the add-on components in accordance with the
relevant installation instructions.
⇒ "4.5 Setting
13. Remove the roof bars before
Audi A7 Sportback 2011
No. 122, Body, Edition 10.2010
A
a
B
a
C
A
B
A
4 Installing/removing roof bars on vehicle
6
ZUB-0336
13
15
15
ZUB-0337
A
14
ZUB-0334
11