Audi A7 Sportback 2011 Fitting Instruction page 11

Installing the roof bars
–
Carefully position both roof bars on the vehicle roof in
the area of the positioning bolts -X- and -Y-. The claw
fasteners must be in the installation position when
positioning the roof bars. Observe the labels -23- on the
underside of the profile tubes when positioning the roof
bars.
Note
The labels must be on the left-hand side of the vehicle and
♦
the printed arrow must point in the direction of travel.
When installing the roof bars, the vehicle doors can remain
♦
closed because the positioning bolts are accessible from
outside the vehicle.
Installing the rear roof bar
–
Pull the rubber seal gently outward and carefully insert
the installation aid -14- between the positioning bolts and
rubber lip. Now position the installation aid so that it is
centred with the positioning bolts -Y-. The positioning bolts
-Y- must be visible.
–
Unhook the claw fastener -12- from the installation
position on the support bracket- 9- by pulling upward, then
swivel down.
Note
The illustration shows the installation of the rear roof bars.
Audi A7 Sportback 2011
No. 122, Body, Edition 10.2010
Y
X
X
Y
9
4 Installing/removing roof bars on vehicle
6
Y
Y
X
ZUB-0789
Y
14
ZUB-0790
12
Y
Y
12
14
ZUB-0791
9