Table of Contents
Advertisement
NOTE
Please read the
Attention
Upgrade Previous Devices First
2.x or earlier that you wish to use with ioMemory VSL software version 3.x, you must upgrade the firmware
on the previously installed devices before installing new devices in the system. See the IBM ioMemory VSL
Release Notes
Installation Instructions
Attention
Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded
before beginning any hardware installation procedure.
Attention
Do Not Disassemble the Device
product warranty. Removing (and replacing) the bracket as instructed in this guide is
disassembly
These installation instructions are for any IBM IBM High IOPS Adapter.
1.
Locate the serial number label(s) on your device and record the number(s) for future reference.
NOTE
The serial number label(s) will have a number and a barcode.
NOTE
Visible in fio-status
will be visible in the
2.
Turn off the computer and disconnect the power cable.
3.
Remove the computer's access panel. Locate an available PCIe slot compatible with the device. See
Requirements
for PCIe slot requirements.
NOTE
Consult your computer's documentation for details on removing the panel and identifying PCIe slots.
IBM High IOPS Adapter Hardware Installation Guide for ioMemory VSL 3.2.2
[no notes on this page]
Hardware Requirements
if you have not done so.
: If you have IBM High IOPS Adapters configured for ioMemory VSL
for full Upgrade Notes.
: If you disassemble your IBM High IOPS Adapter, you will void the
: Once the ioMemory VSL software is installed, the device's serial number(s)
ioMemory VSL software utility.
fio-status
Installing the Device
not
considered
______ _
|
- 12 -
Hardware
_
12
Advertisement
Table of Contents
