Driving Mode Of Electric Lock (Default In Active Mode) - Planet HDP-5240PT User Manual


Power Connector
The HDP-5240PT requires either IEEE 802.3af/at PoE or DC power from the power connector.
It shows the two-pin connector comes with a power source of 12V DC, 1A (max.).

Network Connector

Power and Electric-lock Connector
1 2
+12V VSS
12V DC, 1A

3.1.3 Driving Mode of Electric Lock (Default in active mode)


JP1 Jumper
There are two modes for power supply of electric lock as shown in the picture below.
(The default is "Active Mode".)
Passive Mode: When the electric lock starting current is more than 12V/650mA, the electric lock interface for
short circuit output control in the external drive mode is used.
Active Mode: When the electric lock starting current is less than 12V/650mA, the electric lock interface with
12V DC output in the internal drive mode is used.
When the device is in the active mode, the maximum switch output is 12V, 650mA; if the
electric lock needs power supply over 12V 650mA, it will ask the device in the passive
mode to get an additional power to drive the lock to switch on/off.

When using the active mode, it is 12V DC output.

When using the passive mode, output is short control (normally open mode or
normally close mode).
CN7
3 4 5
NC COM NO
Electric-lock switch
Jumper in passive mode
720p SIP Multi-unit Video Door Phone with RFID and PoE
6 7
S_IN S_OUT
Indoor switch
Jumper in active mode
23
HDP-5240PT