Install The Open Flue Kit; Attaching Top Air Deflector - Wonderfire 530U PRESIDENT Installer's Manual

5.4.

Install the Open flue Kit

5.4.1. Fit the flue adapter unit
1. Remove the rear outer flue collar and seal by
unscrewing 12 screws (See figure 5).
2. Fit the rear cover plate (supplied with the kit) using the
seal and 12 screws previously
removed. The hole in the cover
plate must be nearest the top edge
(See figure 6).
3. Remove 4
screws from
the case back
(2 each side
just outside the
cover plate).
Fit the adapter
unit to the case
using these
screws
(See figure 7).
4. Fit a "P"
clip at the
bottom rear
Figure 8
right corner of
the appliance
case. Fit the flue switch lead to the clip (See figure 8).
Feed the lead into the case through the hole at the
bottom corner.
5.4.2. Adapting Burner Module
1. Detach the battery shield by removing two
screws. See figure 9.
2. Detach the burner module by removing 11
screws. See figure 9.
3. Fit a "P" clip at the right side of the inside of the
case. Fit the flue switch lead to the clip. See figure
10.
4. Disconnect the thermocouple from the valve
block. See figure 11.
5. Fit the thermocouple interrupter to the valve
block. See figure 12.
6. Connect the flue switch leads into the thermocouple interrupter. Screw
the thermocouple into the interrupter block until finger tight. Make sure
that the leads are properly located and finally tighten the thermocouple nut
firmly to ensure good contact. See figure 13.
7. If the appliance is to be fixed to the floor, don't attach the burner module to the appliance
yet. Wait until the appliance is accurately positioned with the flue system attached. The holes in
the appliance base for floor fixing are not accessible when the burner module is fitted.
5.5.

Attaching top air deflector

Fit the top air deflector under the top panel of the appliance case. Secure
with two thread cutting screws. See figure 14.
Figure 6
Figure 7
Figure 10
Figure 11
Figure 5
Figure 9
Figure 12
Figure 13
Figure 14
9