Fitting Sides & Switch - Wonderfire 530U PRESIDENT Installer's Manual

7 .
1. a) If fitting with appliance side switch only
• Snap fit the switch into the opening in the switch mounting bracket. See figure 15
• Fit the two switch lead clips to the right side of the case.
• Route the switch leads round the back of the valve and connect to the control unit.
• Connect the battery box to the black connection pad. See figure 16.
• Place the battery box on the "Velcro" pad in front of the battery shield. Fit the leads
into the clips. See figure 16.
b) If fitting remote control as only active switch (Appliance side switch
disconnected)
Caution! Don't connect the batteries in the remote control receiver until the
leads are connected to the burner control unit. A short circuit could result in
destruction of the electrical components.
• Route the leads from the receiver round the back of the burner and connect to the
control unit.
• Remove the receiver lid. Connect the battery box to the receiver leads. Fit the four
1.5 V batteries. Replace the receiver lid.
• Place the remote control receiver on the "Velcro" pad in front of the battery shield.
See figure 17.
• Fit the 9V battery to the handset transmitter.
c) If fitting remote control and active side switch
Caution! Don't connect the batteries in the remote control receiver until the
leads are connected to the burner control unit. A short circuit could result in
destruction of the electrical components.
• Snap fit the switch into the opening in the switch mounting bracket. See figure 15.
• Fit the two switch lead clips to the right side of the case.
• Cut off the "L" terminals from the switch leads on the remote control receiver and
remove insulation from approximately 6mm (¼in) at the ends of the leads. See figure
18.
• Securely connect the leads to the terminal block. Connect the black lead to the
terminal opposite the brown lead. Connect the lead with the white stripe to
the terminal opposite the yellow lead. See figure 19.
• Route the leads round the back of the valve and connect the "L" terminals to the
control unit.
• Remove the remote control receiver lid. Remove the cover from the white connection
pad. Fit this connection pad to the remote control receiver terminals. See figure 20.
• Fit the black connection pad to a battery box. Fit four 1.5V batteries. See figure 20.
• Place the batteries and connection pad in the receiver box and replace the lid.
• Fit the 9V battery to the handset transmitter.
Figure 20
F I T T I N G S I D E S & S W I T C H
Figure 15
Figure 16
Figure 17
Figure 19
Figure 18
11