Final Review; Servicing - Wonderfire 530U PRESIDENT Installer's Manual

1. Recheck ignition and all controls
2. Instruct the user on the correct operation of the fire and especially mentioning:
a) The fire has a pilot. To light the pilot, the gas control knob must be operated as
described in the owner's guide.
b) The pilot flame can be viewed through the hole in the front ceramic fuel effect
at the left side.
c) If the room is left empty while the heater has shut down to pilot only
alight, warn that the flames will relight if the temperature in the room
drops sufficiently. Therefore combustible objects should be kept away
from the fire.
d) The stove may give off a slight odour while new and that the flames may be the
full height of the fire box, or even slightly higher, for the first few hours of
operation due to burning of released curing compounds used in the manufacture
of the appliance. Assure the customer that the release and burning of these
compounds is perfectly safe and is not a health hazard. Mention that the flame
height will reduce to normal levels and the odour will disappear a few hours after
initial operation of the appliance.
e) When first turned on, the decorative flames will appear predominantly blue. After
approximately 15 minutes the flames will turn yellow.
f) Emphasise that if the glass panel is broken or damaged, the fire should
be turned off and not used until the window unit is refitted with an
authorised replacement.
g) Recommend that the appliance and its flue system should be serviced by a
competent person (In the UK a CORGI registered person) at least annually. If the
appliance is in premises in the United Kingdom occupied by a tenant, point out that by law a
landlord must have any gas appliance, flue and pipework which is situated in a tenant's
premises checked for safety at least every 12 months
h) If the fire goes out for any reason, wait at least five minutes before relighting.
3. Hand over to the customer this guide and the users guide.
4. Advise the customer to read the Owner's Guide before operating the stove and always
to follow the advice in the section headed "Cleaning".
• Always turn off the gas supply before commencing any servicing
• This product uses fuel effect pieces, burner compartment walls and gaskets containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres. Excessive
exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract.
Consequently, it makes sense to take care when handling these articles to ensure that the
release of dust is kept to a minimum. To ensure that the release of fibres from these RCF
articles is kept to a minimum, during installation and servicing we recommend that you use a
HEPA filtered vacuum to remove any dust and soot accumulated in and around the fire
before and after working on the fire. When replacing these articles we recommend that the
replaced items are not broken up, but are sealed within a heavy duty polythene bag, clearly
labelled as RCF waste. This is not classified as "hazardous waste" and may be disposed of at
a tipping site licensed for the disposal of industrial waste. Protective clothing is not required
when handling these articles, but we recommend you follow the normal hygiene rules of not
smoking, eating or drinking in the work area and always wash your hands before eating or
drinking.
• Check that the appliance is clean and that no matter is blocking the burner or pilot
which may cause an imperfect flames or prevent a correct electrode spark.
•
After servicing, make sure that the ceramic walls and fuel effect pieces are replaced
correctly as described in the installation instructions.
• Always test for gas soundness after servicing the appliance.
1 3 . F I N A L R E V I E W
1 4 . S E R V I C I N G
19