Appliance Preparation; Detach The Window; Check Ignition Spark; Check Flame Control Motor - Wonderfire 530U PRESIDENT Installer's Manual

5 .
Figure 2
Figure 3
Figure 4
8
A P P L I A N C E P R E P A R A T I O N
5.1.

Detach the window

1. Release the top of the window by pulling forward and rotating outwards the two bars at the
top corners. See figure 2.
2. Unscrew the two spring loaded bolts securing the bottom of the window. See figure 2.
3. Carefully lift the window. Keep the window and bolts in a safe place.
5.2.

Check ignition spark

The pilot burner and electrode unit is at the left end of the burner.
Push in the lighting knob and turn anticlockwise through the "IGN" position to "PILOT". A
spark should flash across from the pilot electrode to the pilot burner shield. See figure 3.
5.3.

Check flame control motor

1. Fit the four batteries into the battery box (Which is attached to the switch leads).
2. Temporarily connect the black connector pad to the control unit – See figure 4.
3. Operate the switch. This should cause the flame control knob to rotate anticlockwise. See
figure 4.
4. Disconnect and remove after checking.