Table of Contents
Advertisement
Direct/Step Mount (No Bracket)
When using the direct mount installation shown below, you MUST turn on the Flip
Left/Right feature. Refer to your Operation manual for more information.
3/32 Drill bit (Direct/Step mount pilot holes)
To use Direct Mount:
1.
Make sure the boat's step is the same length or longer than the
StructureScan transducer.
2.
After selecting a mounting location, route the transducer cable to
the location where the LSS-1 will be installed.
3.
Hold the transducer
in
the
position and then use
a pencil to mark pilot
holes
mounting holes on
the transducer.
4.
Drill the pilot holes.
5.
Apply a high-grade
above-
waterline sealant to
the pilot holes.
6.
Align the transducer
mounting holes over
the pilot holes and
mount the transducer
to the step using self-tapping metal screws (not supplied). Do NOT
overtighten the screws; otherwise you could strip out the fiberglass
pilot holes or crack the mounting holes on the StructureScan
transducer.
7.
Connect the transducer cable to the LSS-1 and then turn on the Flip
Left/Right feature in your display unit.
NOTE: When using a Direct Step Mount, you must turn on the Flip
Left/Right feature in your display unit to ensure what is shown on the
left/right side on your display, corresponds with what is on the left/right
Direct Step Mount Supplies (not included
desired
through
the
or
below-
Marine grade above- or below-
waterline sealant
View underneath the step
side of your boat.
9
)
Do not install
under boat hull!
Hide quick links:
Advertisement
Table of Contents
