Lowrance StructureScan Installation Manual page 7

Jackplate Mount
You can mount the StructureScan transducer inside or outside of the jackplate by
drilling through the jackplate, then inserting bolts though hinge hole in the side of
the bracket mount into the jackplate.
M6 or 1/4" Drill bit (Jackplate Mount) pilot holes
To Mount StructureScan on Jackplate:
1. Choose a transducer location on the inside or outside of the
jackplate.
2. Adjust the jackplate up and down to make sure the transducer will
not obstruct jackplate movement.
3. Make sure nothing blocks the
sonar beam on either side of
the StructureScan transducer.
4. Route the transducer cable to
the location where the LSS-1
will be installed.
5. Move the transducer bracket
into the desired position and
then use a pencil to mark the
holes through the hinge hole
and hole in the bracket mount
on the side of the bracket.
6. Using a M6 or equivalent drill
bit, drill the holes into the
jackplate.
7. Slide the bracket inside the
jackplate and align the bracket
holes with holes you drilled in
the jackplate.
8. Slide M6 bolts with washers
into each hole on the side of
jackplate.
9. Guide the bolts through the StructureScan bracket holes.
10. Place a washer over the end of the bolts and tighten the nuts.
11. Connect the transducer cable to the LSS-1 sonar port.
Jackplate Mount Supplies (not included)
1/4" (M6) jackplate mount bolts
StructureScan bracket
mounted inside the
jackplate. The bracket
can also be installed
on the outside of the
jackplate.
7
Jackplate