Appendix B.4 Wi-Fi Access Point Network Settings; Figure 32: Fs-Gui Wi-Fi Ap Network Settings - Siemens ProtoAir FPA-W44 Startup Manual

Appendix B.4 Wi-Fi Access Point Network Settings

From the FS-GUI Network Settings landing page, click on the Wi-Fi AP tab. To change the Wi-Fi AP
settings, follow these instructions:
•
The Access Point Status Field must be ENABLED to allow connecting to the ProtoAir via Wi-Fi.
•
Modify the Settings manually as needed, via these fields: Access Point SSID, Access Point
Password, SSID Broadcast, and Channel.
NOTE: The default channel is 11.
•
Click Update Wi-Fi Settings, then click on the System Restart to restart the Gateway and activate
the Wi-Fi settings.
NOTE: If the FS-GUI was open in a browser via Wi-Fi, the browser will need to be updated with the
new Wi-Fi details before the ProtoAir FS-GUI will be accessible again.
Wi-Fi AP Fields
Connection Status
MAC Address
Tx/Rx Msgs
Tx/Rx Msgs Dropped

Figure 32: FS-GUI Wi-Fi AP Network Settings

Status of connection
Access point's MAC Address
Number of transmitted and received messages
Number of unanswered Tx or Rx messages
Page 41 of 66
Siemens ProtoAir Start-up Guide
Definition